EasyManua.ls Logo

SystemAir Villavent VR 400 DC - Troubleshooting Common Issues; Fan and Airflow Problems; Control and Air Quality Issues

SystemAir Villavent VR 400 DC
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Luftzirkulation (Fig 7)
Um eine zufriedenstellende Luftzirkulation zu erhalten, sollten entweder die
Türenblätter etwas gekürzt, die Türdichtungen entfernt oder sonstige
Öffnungen zum Überströmen der Luft in Tür oder Wand geschaffen werden (je
Abluftventil ca 70 cm2 freier Querschnitt).
Holzöfen, Kamine, Dunstabzugshaube, Wäschetrockner... (Fig.8)
Wenn das VR Gerät installiert ist, ist eine ausgeglichener Zu- und Abluftstrom
gegeben, so daß im Gebäude normalerweise kein Unterdruck herrscht. Es
besteht also keine Gefahr der Rücksaugung von Rauch oder Küchendunst
durch die Wohnraumlüftung.
Eine offene Feuerstelle benötigt ca. 154-300 m
3
/h Frischluft. Hierfür ist eine
Zuluftöffnung von 300 cm2 erforderlich. Die Zuluft wird am Besten durch einen
separaten Frischluftkanal direkt an den Kamin/Ofen herangeführt.
Auch wenn eine Dunstabzugshaube an das Gerät angeschlossen ist, kann
eine gleichmäßige Be/Entlüftung aufrechterhalten werden, selbst wenn die
Haube in Betrieb ist. Allerdings muß für eine separate Zuluftversorgung für die
Haube gesorgt werden.
KLEMPNERARBEITEN
Air circulation between rooms (Fig 7)
To obtain a satisfactory air circulation, a small gap should exist around the doors
between rooms with inlet diffusers (living rooms and bedrooms) and rooms with
extract points (bathroom, WC, kitchen, laundry rooms etc.). Install doors with slot
in the frame, doors without door sill or slots/vents in doors/wall (min. 70 cm
2
free
area per extract diffuser).
Fireplace, kitchen ventilator, tumble dryer etc. (Fig. 8)
Balanced ventilation is obtained where the VR units is installed. There will
normally be no under pressure in the building, and therefore no risk for back
draught from fireplace or chimney.
An open fireplace requires an air supply of 150 - 300 m
3
/h (42 - 84 l/s) for
maximum functionality and efficiency. This equals 300 cm
2
ventilation slots per
fireplace. Supply air duct directly to the fireplace would be the optimal solution,
but 2 pcs. 16x16 cm closing vents in outer wall is a good alternative.
16x16 cm vents could be installed for air supply to tumble dryer and kitchen
ventilator (one for each). These should preferable be installed in the same room.
An open window will also give the required air supply to fireplace, kitchen
ventilator and tumble dryer.

Other manuals for SystemAir Villavent VR 400 DC

Related product manuals