Need help?Do you have a question about the TA DISCOVERY DMA 850 and is the answer not in the manual?
General| Brand | TA |
|---|---|
| Model | DISCOVERY DMA 850 |
| Category | Measuring Instruments |
| Language | English |
Overview of the document's content and purpose.
Important safety notices, cautions, warnings, and regulatory standards.
Explains the use of notes, cautions, and warnings for critical instructions.
Lists safety standards for Canada, European Economic Area, and United States.
Addresses high voltage hazards and safe maintenance practices for electrical components.
Provides precautions for using liquid nitrogen, including ventilation and protective gear.
Covers hazards of hot/cold surfaces and high-pressure air systems.
Guides on lifting the instrument safely and handling samples that may emit hazardous gases.
Introduces the DMA 850 and details its main system components.
Describes the DMA 850 instrument and its user interface, including buttons and panels.
Details the buttons for main instrument functions like Start and Stop.
Describes functions available in the View panel for instrument status and operation.
Explains panels for network, calibration, service, and test variable information.
Lists technical specifications for dimensions, power, operating conditions, and temperature ranges.
Describes optional clamps and accessories available for the DMA 850.
Instructions for unpacking, inspecting, and installing the DMA instrument.
Guide to checking the instrument for shipping damage and missing parts upon receipt.
Recommends guidelines for selecting an appropriate environment for DMA installation.
Covers procedures for powering the instrument on and off, including startup and shutdown sequences.
Instructions for installing and removing the standard furnace component of the DMA.
Details how to connect power, communication cables, and gas lines to the instrument.
Details the process for installing the moisture guard accessory to protect electronics.
Describes the DMA's rear panel ports and their functions.
Provides steps for installing and removing the standard cantilever clamps.
Provides steps for installing the standard single/dual cantilever clamp.
Outlines the procedure for safely removing the single/dual cantilever clamp.
Explains the requirements and connection of gas supplies for the air bearing system.
Step-by-step guide for connecting the air filter regulator to a lab air source.
Instructions for connecting the air filter regulator to the Air Compressor Accessory.
Procedures for installing the cooling gas line for air cooling functionality.
Covers communication setup, power switch, and cable connections.
Covers the necessary steps for establishing communication between the instrument and controller.
Details the main power switch and how to connect the power cables to the instrument.
Outlines the general procedure for performing experiments with the DMA 850.
Ensures the DMA 850 and controller are properly installed and ready for experiments.
Details essential calibration procedures for accurate experimental results.
Calibrates the absolute position of the drive shaft using the optical encoder.
Adjusts force exerted by the clamp and registered by the instrument.
Checks installation stability and ensures all feet are in contact with the table.
Compensates for phase shift caused by instrument characteristics.
Calibrates the properties of the installed DMA 850 sample clamp.
Guides through the basic steps to perform a DMA experiment.
Covers choosing, installing, and calibrating clamps, preparing samples, and starting experiments.
Provides instructions for correctly positioning thermocouples within the furnace cavity.
Explains how to choose an operating mode for different experiment classes using the control software.
Details the process of setting parameters, mounting samples, and initiating experiments.
Covers initiating, discontinuing, and removing samples from experiments.
Covers primary maintenance tasks that are the customer's responsibility.
Provides instructions for cleaning the DMA 850's user interface screen.
Recommends periodic cleaning of the furnace interior for optimal performance.
Lists items included in the DMA 850 accessory kit.
Provides a list of other available replacement parts for the DMA 850.
Details the different clamp kits available for various experimental needs.
Lists major accessories like compressors and chiller systems for the DMA 850.
Describes the organization and items within the DMA 850 accessory case.
Details the items stored in the top layer of the DMA 850 accessory case.
Details the items stored in the bottom layer of the DMA 850 accessory case.
To Next Page
