TACKLIFE TKD250 - Installation Requirements; Electrical Requirements; Location Requirements

INSTALLATION REQUIREMENTS
Electrical Requirements
"T"
Electrical Shock Hazard
Always plug into a grounded three-prong outlet.
Do not remove ground prong.
Do not use an adapter.
I Do not use an extension cord.
i Failure to follow these instructions can result in death,
: fire, or electrical shock.
Specific electrical requirements are listed in the chart below.
Followthe requirements forthe type of plug on the power
supply cord.
Power Supply Requirements
w 115V (103.5 min. to 126.5 max.)
w 15Atime-delay fuse or circuit breaker
Recommended Grounding Method
MmF
This dehumidifier must be grounded. This
dehumidifieris equipped with a powersupply
cord with a three-prong grounding plug.The
cord must be plugged into a mating, grounded
three-prong outlet, grounded in accordance
with a|||oca| codes and ordinances. If a mating
outlet is not available, it is the customer's
responsibility to have a properly grounded
three-prong outletinstalled by a qualified
electrician.
It is the customer's responsibility:
w To contact a qualified electrical installer.
w To assure thatthe e|ectrica|insta||ation is
adequate and conforms to the Nation
Electrical Code, ANSI/NFPA 70-last edition,
and alllocal codes and ordinances.
Copies of the standards listed may be obtained
from:
Nation Fire Protection Association
1 Batterymarch Park
Quincy, Ma 02169-7471
www.nfpa.org
Location Requirements
mTTTrF1To reduce the risk of injuryto persons, malfunction, ordamage tothe product or
property when using this appliance, follow basic safety precautions, including the following:
NOTE: Your model may differfrom the one shown.
_.--- A
_..._ .....
A
w Do notlocate outdoors. This dehumidifieris intended forindoor,
residential use only. This dehumidifieris not recommended for
commercial use.
w Allow atleast 12"to 18" (30.5 cm to 45.7 cm) of space on the rear
and sides of the dehumidifierfor models with backlouverand
above the dehumidifierfor models with top louvers.
w You will need a surface strong enough to supportthe
dehumidifierwhen its bucket is full of water.
n You will need.a surface level enough to keep the water from
spilling when the bucketis full of water.
w Do not block the louvers of the unit.
w Never operate this dehumidifierin an area thatis likely to
accumulate standing water. If this condition develops, for your
safety disconnectthe power supply before stepping into the
water.
5