Taco 554-7 - User Manual

To Next Page

Plant I.D. 001-4225 EFFECTIVE: June 1, 2014

102-500

Instruction Sheet

554-7 Wireless Remote Transmitter & Receiver Kit

554-8 Wireless Transmitter Button

Model #: 554-7 Wireless Remote Transmitter & Receiver Kit

Kit Includes: 1 Remote Receiver

3 Wire Nuts

1 Remote Transmitter Button

INSTALLATION INSTRUCTIONS

1. The remote receiver is the small black rectangular box with three protruding wires

(white, black, green). Connect the white, black, and green wires from the remote

receiver directly to the corresponding white, black, and green wires on the On

Command control box by twisting each same colored wire together with the wire

nuts provided.

2. When installing the remote receiver under a sink, mount the remote receiver toward

the front of the cabinet (transmitter range is about 70’). If the transmitter button will

activate the pump from a short distance, but not from further away, the receiver may

need to be relocated for better reception. Strapping the receiver to the front of the

drain trap facing outward will optimize reception.

3. NOTE: The remote transmitter button included with the remote is synced for

use. It does not need programming.

4. For additional Wireless Remote Transmitter Buttons, use model 554-8.

Need help?

Do you have a question about the Taco 554-7 and is the answer not in the manual?

Summary

Taco 554-7 Wireless Remote Transmitter & Receiver Kit

Installation and Mounting

Instructions for connecting receiver wires and positioning the receiver for optimal reception.

Accessory and Usage Notes

Information on the pre-synced transmitter button and purchasing additional buttons.

Taco 554-8 Wireless Transmitter Button Programming

Synchronization Procedure

Step-by-step guide to program (sync) the 554-8 transmitter button with the remote receiver.

Taco Limited Warranty Statement