Turret Console 182 FlexSet 120/280 User Guide
Display Message Key LED
Operating a primary FlexSet
You can control a call conducted at a primary FlexSet using the Hold, Transfer
and Toggle Between Calls functions programmed into buttons on the primary
FlexSet and all six expansion modules.
Operating a partner FlexSet
To control a call initiated at a partner FlexSet, use buttons of the partner
FlexSet only.
Button Programming
Buttons on the expansion modules attached to the primary FlexSet can be
programmed in the same way as buttons on the FlexSet itself.
Buttons on the expansion modules attached to the partner FlexSet can be
programmed with dial numbers, Loop, Boss Group lines, Page_Q, Wait_Q.
The three primary expansion modules can be programmed from the primary
phone only. The three partner expansion modules can be programmed from the
partner phone only.
For the instructions on buttons programming refer to page 135.
To Next Page
Loading...
