Conference, Multiparty 46 FlexSet 120/280 User Guide
Display Message Key LED
Conference, Multiparty 7098-7099
Conference calls allow several users to join a multiparty conversation. Up to 6
or 15 participants are permitted depending on the system hardware assigned to
the conference call. You may use any one of the following:
• Meet Me Conference • Conference Release • Group Calls (see page 73)
• Progressive Add-on • Lock
MEET-ME
To Join a Conference:
(at the assigned hour)
Dial assigned conference number 7098-7099 or press [CONF#] ANSWER (CONF#)
ON
Note: Warning tone is heard by all participants.
To leave a conference:
Press [SPKR] or hang up.
To force release an entire conference:
Press [FORCED RELEASE] (see page 71).
ADD-ON (while connected to a station/trunk)
To add on an additional participant to a progressive conference:
(while connected to a station/trunk)
1. Press
[XFER].
2. Press
[CONFERENCE#] or dial assigned conference number 7098-7099. ANSWER (CONF #)
ON
3. Press [SPKR] or hang up to leave conference.
Note: Warning tone is heard by all participants.
To Next Page
Loading...
