EasyManua.ls Logo

Taiji TSK-130B - Adjust the sake warming temperature; Set the cubic container

Taiji TSK-130B
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-3-
4. Adjustthesakewarmingtemperature.
1) Whenthe
temperature control switch
is
pressedonce,thetemperaturesettingmodeisassumed.
Initialsettingisat[OFF].
Thesettingindicationandthesakewarmingtemperatureareasspecifiedbelow.However,theycan
changeundervariousconditions,andtheyshouldbeusedasaguideline.
Lukewarm Approx.45 °C
Hot Approx.65 °C
2) Eachtimethe
temperaturecontrolswitch
is
pressedonce,thetemperatureindicatorlamp
movesup fromoneafter anotheralongthe
diagonalline.(Fig.8)
<Fig.8>
Heater
Temperature
Control
OFF
3) If the switch is not pressed and such a
conditioniskeptunchangedfor5seconds,the
modeisautomaticallyswitchedovertothe
temperaturedisplaymode
andthe
temperatureinthetankisdisplayed.(Fig.9)
4) Untilthepresettemperatureisattained,the
lampflashestoindicatethepresenttemperature.
5) Whenthepresettemperatureisattained,all
thelampuptothepresettemperaturearelit.
(Asaguideline,whentheHOTtemperatureis
preset,thistemperatureisattainedinabout20
minutes.
<Fig.9>
Heater
Temperature
Control
OFF
5. Setthecubiccontainer.
1)
2)
Removethecapfromthemouthofthecubiccontainer
andconfirmthattheknobfotheaccessorystopcock
issetat“CLOSE”.Thenscrewitin.Sakewillleak
outifthisscrew-inprocessisawkwardlyfollowed.(Fig.15)
Whensettingthecubiccontaineronthesakewarmer,
setthecontainersothatitsmouthispositioned
downwardandtowardyouandthesakeoutletof
thestopcockispositionedtotheleft.(Fig.16)
3) Screwthejointintothesakeoutletofthestopcock.
Thisjointisconnectedtothewarmermainbody.(Fig.16)
4) Beforeyoubegintodispense,confirmthatthe
stopcockjointhoseisfirmlymounted.
Alsoexaminethatthenozzleispulledtowardyou.
5) Turntheknobofthestopcocktotherightandadjust
ittothe“OPEN”position.(Fig.17)