Taiji TSK-130B - After Use; Daily maintenance (cleaning of sake passage); Water in the water bath tank should be replaced once a month; Care of main unit

-5-
AfterUse
1. Dailymaintenance(cleaningofsakepassage)
(1) Removetheusedcubiccontainerinthefollowingprocedure:
・LeavethepowerswitchturnedON.
1) Turntheknobofthestopcocktotheleftandadjustittothe
“ CLOSE ” position.Throwthenozzle(sakeoutlet)
downtodrainthesakeremaininginside.
2) Afterthenozzlehasbeenthrowndown,removethejointpartbetweenthestopcockandthejointhose.
Foramachinethathasnosakelevelindicator,theinnersakecannotbedrainedunlessthisworkisfinishedfirst.
3) Whentheinnersakehasbeendrainedout,returnthenozzleandremovethecubiccontainerfromthe
mainbody.
4) Removethestopcockfromthecubiccontainer.
(2) Pourabout2litersofhotwater(below.70℃)inacubiccontainerintendedforcleaning(anemptycubiccontainer).
Aftermountingthestopcock,placeitonthemainbodyandconnectthestopcocktothejointhose.
・Neveruseanydetergent.
(3) placeanemptycontainerunderthenozzletodrainhotwater.Turntheknobofthestopcocktotherightand
adjustittothe
“ OPEN ” position.Pushthenozzlestraightdownorpressthe “ manualdispensingswitch. ”
(4) Hotwatercomesoutofthenozzleandthepipeinsideiscleaned.
(5) Aftercleaning,removethecubiccontainerforcleaningintheprocedureof(1)aboveandturnthepowerswitchoff.
・Thedrainedsakeshouldbeusedforcookingandsoon.Aftercleaning,however,somewaterdropsmay
remaininside.Whenyoudispensesakenexttime,drainsomeatthebeginning.
2.
3.
Waterinthewaterbathtankshouldbereplacedonceamonth.
Atthattime,turnoffthepowerswitchwithoutfailandopenthewaterdrainvalve
connectingthedraintubingtodrainwater.
4.
5.
Cleanthenozzleatleasttwiceamonth.(Fig.22)
Gentlyscrubthesensorelectrodeonthetipofthenozzlewithatoothbrush.
Maintenanceforserverbottleholderandtray
Removetheserverbottleholderfromthemainunitand
removethetrayfromtheserverbottleholder.
Neatlywashthemwithwarmwater.
<Fig. 22>
Nozzle
Sensor
Careofmainunit
Wipemainunitwithadrycloth.Otherwise,wipeitwithaclothdippedinaneutraldetergent
solutionorsoapandwater,thenwipeitwellwithadrycloth.
Thefrontofthemachineismadeofresin,sodonotusepaintthinnerorothervolatilefluidsoralkaline
detergents.