Need help?Do you have a question about the Tailfin AeroPack and is the answer not in the manual?
General| Brand | Tailfin |
|---|---|
| Model | AeroPack |
| Category | Bicycle Accessories |
| Language | English |
Orient the Arch using the Tailfin logo for correct pannier angle.
Place dropout on Arch with sloped side facing outside.
Ensure quick release pin faces backwards on dropout.
Attach dropouts to the Arch using countersunk screws and tighten to 5Nm.
Install the first connector piece by pushing it into place.
Install the small connector piece onto the Arch.
Rotate both connector parts together and secure with M5*10mm screw to 5Nm.
Align the front connector part, ensuring the bag strap is seated beneath it.
Install the connector part using countersunk screws, tightening to 5Nm.
Align the Arch correctly and attach to the bag with screws, tightening to 5Nm. Silver pins face up.
Open the fast-release dropouts on the bike.
Clamp the dropouts around the axle or frame mount adaptors.
Secure the seat post connector in place.
Ensure seat post connector teeth are closed and the clamp is locked for safe riding.
Do not use the release button for attachment; ensure clamp is locked before riding.
Security Torx key and screws are provided with Fast Release Dropouts.
Install screws to secure the Fast Release Dropouts to the axle.
Compress bag by opening Direct Access Pocket before rolling shut to reduce size. Close zip.
Cross straps into an 'X' to secure the bag when travelling light.
To Next Page
