EasyManua.ls Logo

Tait Orca series - Page 36

Tait Orca series
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C - 12 Diagnostics and fault finding 11/98 IPN: 449-51000-01
Figure C-4: Fault finding – Receive faults
NONO
YES
NO
NO
YES
NO
YES
Receive faults
Is the radio in lock
(command 72)?
Is the radio programmed
correctly?
Is the receive sense
>-117 dBm?
Is squelch operating normally?
16 dB city, 12 dB country
Does speaker
Z = 16 ohms?
Are the speaker contacts
functioning?
Replace on/off/volume
control switch.
Replace speaker contacts.
Replace speaker.
Recalebrate squelch.
Reprogram radio.
Check programming. Are
channels programmed correctly.
Is the frequency/band
information correct?
Does on/off/volume pot vary
between 180 ohms to 10 k
between pin 3 and GND and
between pin 2 and GND?
YES
NO
YES
YES
NO
YES
NO
YES
NO
YES
Return to Mobile Radio
Customer Service Department

Table of Contents

Related product manuals