To stop the machine
96
Chapter 5
PT10
4-3. To stop the machine with needle bar stuck in the material (Stop at Lower D.Point)
This setting stop the machine with needle stuck in the material at the end of embroidery. This function is
effective for embroidering to consecutive design using AFC (option) mainly.
4-3-1. Explanation on the screen
4-3-2. How to operate
The following is the example of setting "Stop at Lower D. Point".
(1) To open screen
(2) To set Stop at Lower D. Point
YES: To set
NO: Not to set (usual setting)
10 Stop at Lower D. Point
NO
10 Stop at Lower D. Point
NO
To Next Page
Loading...
