To increase embroidering efficiency
127
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
UO04
(4) To select NO (Not to perform Automatic Data Set of the design)
(5) To select YES (Delete the design automatically)
8-7. Embroidering multiple name designs (continuous names)
This function allows you to embroider multiple names saved in a single design based on the stop code.
• This function can not be set during embroidery.
• Perform thread trimming based on the step-by-step color change code. If a different color change setting
is used, the color is changed and the next step is displayed on the main screen.
• Even if "Auto Start (AS)" or "Auto start at same color" is set to YES, auto start will not occur after color
change when in continuous name mode.
• If "Auto Color Change (AC)" is set to NO, the machine temporarily stops before color change but the main
screen displays the step design before color change. After restart, the machine changes the color to the
next step color and temporarily stops and the main screen displays the step design after color change.
• The machine temporarily stops before exceeding the next step during Frame Back/Frame Forward by the
Stop switch.
8-7-1. Explanation on the screen
YES: To set (Continuous name mode)
NO: Not to set
To Next Page
Loading...
