TAJIMA TMBR-SC - Page 249

Cleaning
233
Chapter 10
1
2
3
4
5
6
7
8
9
10
11
UO04
(4) Presser foot shaft (TMBR-SC)
The motion of the presser foot shaft may be getting poor because of adhering thread and dust. Clean
the surrounding of the presser foot shaft using an air compressor or an brush periodically.
Cleaning cycle: Twice/week
(a) Lower the presser foot by operating (SET + E) on the operation panel.(p.18)
(b) Clean the presser foot shaft.
Presser foot shaft
An example when using an air compressor