Takeuchi TB175 - Page 129

126
MAINTENANCE
Every 1000 Hours
Inspecting and Adjusting the
Engine Valve Clearance
This operation requires experience. Have it
performed by a Takeuchi sales or service
outlet.
Retightening the Engine Cylinder
Head Bolts
This operation requires experience. Have it
performed by a Takeuchi sales or service
outlet.
Inspecting the Engine Fuel
Injection Pressure and Spray
Condition
This operation requires experience. Have it
performed by a Takeuchi sales or service
outlet.
Replacing the Travel Motor Gear
Oil
Refer to page 119 “Replacing the Travel
Motor Gear Oil”.
Replacing the Air Breather Filter
WARNING
¡¡
¡¡
¡Never jump off the machine. Use the
steps and handrails when climbing on
and off the machine, and always
support your body at three points with
your hands and feet.
¡¡
¡¡
¡Oil may spurt out if caps or filters are
removed or pipes disconnected before
releasing the pressure in the hydraulic
system.
• Gradually press the air breather
button to relieve tank pressure.
1. Remove cap nut (N) on the air breather.
2. Press botton (T) and bleed the air from
the tank.
3. Remove seal washers (W) and nut (G).
4. Remove cover (H).
5. Replace filter (A), making sure it is in the
proper direction.
6. Line up the cut section of body (B) and
cover (H) and install.
7. Install seal washers (W) and nut (G).
8. Tighten securely by hand with cap nut (N).
N
W
G
W
H
A
T
B
L2G023