OPTIONS
191
Telescopic Arm
Inspection and Maintenance
Greasing
¡Every day or every 10 hours
¡Type of grease ..... Lithium-based multi-
purpose grease No. 2
¡Greasing points
1. Fully extend the bucket and arm cylinders,
lower the boom and on top of block the
bucket.
2. Lower the dozer blade and stop the
engine.
3. Clean the grease nipple.
4. Add grease to the grease nipple using a
grease gun.
5. Wipe off the grease that has been
squeezed out and any extra grease.
Looseness in the telescopic arm
When the telescopic arm is used for long
periods of time, wear may cause the gap
between the outside arm and inside arm to
increase to above the set value, resulting in
looseness.
Other parts may be damaged if the telescopic
arm is used with such looseness. Contact a
Takeuchi dealer for maintenance.
Note that no maintenance is necessary other
than the greasing described above.
OL1L130
To Next Page
Loading...
