131
MAINTENANCE
When Required
Installation
1. Push rubber pin lock (3) into welding
adaptor (4).
Do not let the rubber pin lock stick out past
the welding adapter surface.
2. Install point (2) onto welding adaptor (4).
•Insert the point so that the surface
behind the point’s pin hole is flush or
deeper than the surface behind the
welding adapter’s pin hole.
3. Drive in locking pin (1).
After driving in the locking pin, use a pin with
the same surface as the point surface. Do
not use worn locking pins.
¡¡
¡¡
¡Side cutter
Installation
1. Insert the bolts from the inner of the bucket
and tighten the nuts.
Tightening torque: 241 N·m (178 ft-lb)
2. Caulk the bolts with a punch at three spots
along the periphery of the screw to prevent
the nuts from coming loose.
G4G026
E4G045
3
4
E4G046
4
2
E4G047
1
Improper Proper Proper
To Next Page
Loading...
