To Next Page
N
navarromichaelSep 8, 2025
How to resolve 'TROUBLE TEMP SENSOR' error on Tanaka Test Equipment?
- Jjames56Sep 8, 2025
If you are getting a 'TROUBLE TEMP SENSOR' error, it means the temperature sensor is defective. Replace the Temperature Sensor.
How to resolve 'TROUBLE TEMP SENSOR' error on Tanaka Test Equipment?
If you are getting a 'TROUBLE TEMP SENSOR' error, it means the temperature sensor is defective. Replace the Temperature Sensor.
What to do if nothing appears on the display of my Tanaka APM-7 Test Equipment?
If nothing is displayed, it could be due to the circuit protector being activated. Try pushing the circuit protector pin back into its original position. If that doesn't work, the switching power supply may need to be replaced.
Why doesn't the START key work on my Tanaka APM-7 Test Equipment?
If the START key isn't working, it could be due to two reasons. If other keys also don't work, the MAIN board likely needs replacement. However, if other keys are functioning correctly, the panel switch sheet is probably the issue and needs replacing.
How to troubleshoot if the sampler does not heat in my Tanaka APM-7?
If the sampler isn't heating, it could be either that the heater is burnt out, in which case you should replace the band heater. If the heater is okay, then you should replace the heater relay and/or start SSR.
What should I do if the COOL/WORM key doesn't work on my Tanaka Test Equipment?
If the COOL/WORM key is not working, check if other keys are also unresponsive. If other keys are also not working, the MAIN board may need to be replaced. If other keys work properly, the panel switch sheet likely needs replacement.
What to do if the MODE key is not working on my Tanaka APM-7?
If the MODE key is not working, and if other keys are also unresponsive, the MAIN board needs to be replaced. If other keys work properly, you likely need to replace the panel switch sheet.
What does 'TROUBLE ARM POSITION' mean on my Tanaka APM-7 Test Equipment and how to resolve it?
If you see 'TROUBLE ARM POSITION', it means the arm is not set in place. Set the Arm to the original position before test start.
What does 'TROUBLE FLASH DETECTOR' mean on my Tanaka APM-7 Test Equipment and how do I fix it?
If you see 'TROUBLE FLASH DETECTOR', it means the Flash Detector is defective and needs to be replaced.
What causes the ignition source application to not stop on my Tanaka APM-7?
If the ignition source application does not stop, the stop position sensor (photo micro sensor) in the arm might be defective. Replace the photo micro sensor.
What to do if the displayed screen is not normal on my Tanaka APM-7?
If the displayed screen is not normal, replace the display module.
General| Brand | Tanaka |
|---|---|
| Model | APM-7 |
| Category | Test Equipment |
| Language | English |
