Tanita TBF-310 - General Trouble Shooting

Listed below are common problems and simple solutions.
Please refer to the Technical Notes Booklet for answers to questions regarding accuracy.
ProbUm
Solution
Iha Urn* Dorn No. Turn On whan iK.
(ON/OfFi k«y it p.«»s*d
•Confirm flat the AC adaptrr it property connected to the unit
•Make wire the AC adapter n fugged into a functioning wall outlet
• Make sure only the original Taruta AC adapter U being uted.
TOl* » ditpfayod
•I 01 u displaced when impedance show* abnormal value a* compared to
height and weight
• Do not »tep off the weighty plallorm until aU of the bubble* d^ppear. and the
mntml tun emit* a short beep
•IW make wire the wibfrcl mcawirr. m ban- fret and lhal the- feet are in contact
with the efcdrodr*
•U the individual I* wearing thin nylon* or ha* thick calluw*. place 0.5cc of
conductanl (saline. water) m the center of each electrode Thick nylon* or sock*
will produce an 1-01 trading. They must be removed
'E-11* ii dupiayad
• t • 1 1 fc* drtpUrrd wbrt> fhrrc usa loose connection between the control box and
thr w tn*hin|; p Ib! form
•l onfirm tK»t none oi canrvxtwn hrtwrvn the tcalc and control box an* Ioom* or
unplugged.
• (here ma> hr escrwuvr vacation which will dwtuib the mra*urrmml proewa.
'E-12/13/14' or* deployed
•E-12/13/14 are shown when an mtrtnal malfunitinn ha* incurred. Pleaar call
your nearest Tamta ottice or dealer
T-14" U d-vplay-d
• Make *ure the *ol|nl was mta*ured with baie led. and die leet were In contact
with the electrode* II the subpvt is wearing thin nylon* or ha* thick c«llu*e».
pUe 0Jw ol curshactanl (Milne. water) in thr cenlei ol each electmdr
• Do not *tep oil the weighing platform until all ol the “bubbles' ,l.»app«-ar. and
the control Kn mut* a wall teep
No Print Out
•Confirm the number ol print out* chnwn i* more than 'IT |*er P.I9 or P 25)
•Confirm that the comet brand ol pnrter paper n U-.ng u*ed
•Confirm that the pnrter paper 1* being fed In the proper direction Printc-i paper
will only make an Impression on une *pectai!v treated wdr
•Confirm that the printer » not jammed (See PJ4)
Section 2 of iha p»in. ovf it mining
•The Target Section (Section 2) wgl not print out if the wUstisi I argot Body Fat %
» (01 Select a Target Body Fat % value between IX - 55% to activate die pnnt
out.
Section 3 of th« print out it mining
(IBf-300A)
•The “Wre«let Section* (Section 3) will not print out if the -Wrestler Mode" i*
deactivated See P.21 - 23 for further instructions on activating “Wrestler Mode".
*P-End* is displayed
•Printer paper ha* run out Either press the |CF] key to continue with no pnnt out.
or put another roll in the paper dispmwr. (we IM6V
•Confirm that the pnnter paper i* being fed properly.
•Check the Paper Rr.-jx Lever to make sure it is in die coned “Down* position.