Troubleshooting
There is no power
• Power adaptor is not connected correctly.
• No power at the power outlet.
• Use the wrong adapter instead of he original one included.
• Power button is not turned
on, turn the volume/ON/OFF button clockwise to turn on.
Volume is too low, turn it clockwise to volume up.
Stylus protector is still on.
Tone arm is lift up by the lever.
Volume is not loud enough or not good: connect to the external powered speakers.
Power is on, but the platter does not turn
• Turntable drive belt has slipped off.
• An aux in cable is plugged into the aux in jack, unplug it.
• Bluetooth is connected, disconnect it and reset the mode to "PHO"
Turntable is spinning, but no sound, or not loud enough
USB Recording not working
USB is not formatted in FAT/FAT32
USB flash drive has little room for storage
USB is pulled out when recording is going.
User didn't long press"M" till enter into recording mode.
My record is skipping.
• Use the tone arm lift raise up and down the arm for 10 times before initial spinning.
• Change vinyl records or clean the vinyl records grooves properly.
• The needle is not in the middle of the stylus or broken, replace it.
• Put the record player on the flat surface with 4 legs/corners on the ground.
• The white stylus protector is till on.
To Next Page