SPRAY UNIT
STEP 1
Attach Hose to Unit. Insert hose into the unit with
the bayonet style fitting and turn anti-clockwise
until firmly in place. Avoid over tightening as this
may result in broken components.
STEP 2
Attach power cord and turn power on at the wall
switch.
STEP 3
Turn the unit on and start spraying. The unit is
controlled via three buttons on the front of the
Spray Unit (see below).
ON/OFF SPEED
(Low, Medium & High)
this controls the air flow
HEAT (On/Off)
The unit will heat
the air to warm.
The most common setting is Medium air flow with heat On.
ON/OFF SPEED HEAT
LOW MED HIGH
To Next Page
Loading...
