MAINTENANCE GUIDE
SPRAY APPLICATOR
Step 1 Remove hose.
Step 2 Unscrew solution cup and empty any excess solution. It is
recommended that this be done over a sink or a wet area.
Step 3 Rinse the empty solution cup with warm water.
Step 4 With warm water in the solution cup, spray the water through
the applicator. Use the highest setting for maximum water
spraying when cleaning.
Step 5 Empty solution cup and re-set the solution dial on the back
of the gun to the regular spray setting.
Step 6 Wipe any excess water from the applicator with a cloth and
warm water.
SPRAY UNIT
Step 1 Clean the Spray Unit with a cloth. Avoid using anything
abrasive. Windex and Mr. Sheen are useful products for
maintaining the gloss finish on your Spray Unit.
Step 2 Clean the filter. Remove the filter from the base of the unit
and rinse in warm water. Wait until filter is completely
dry before re-fitting. Positioning the spray unit behind the
spray technician when in use will ensure the unit stays
cleaner for longer.
To Next Page
Loading...
