TROUBLE SHOOTING
If you experience problems with this unit, in the first instance please
read carefully the relevant sections of this User Manual and this Trouble
Shooting section. If you can not solve your problem please contact your
supplier via phone for assistance.
Problem
The Spray
Unit will
not turn on
The spray
applicator
is leaking
The spray is
spluttering
Cause What to do
Power cord not attached Ensure that the power cord
is pushed in firmly to the base
of the unit and wall socket
Electricity not turned on Ensure the power point is on
The unit is not turned on Press the On/Off Button on the
control panel and watch for the
LED light to indicate ON.
Spray Cup is not tight enough Tighten the solution cup
Solution cup seal missing Insert the rubber cup seal
Too much solution Empty some solution from
the spray cup
Nozzle may be blocked Spray warm water through
the applicator
Solution cup low Add solution to the cup
Air speed is set too low Check the filter for blockages
Angled applicator too Keep the applicator on a
sharply while spraying lesser angle while spraying
Nozzle may be blocked Spray warm water through
the applicator
Filter could be blocked Ensure the filter underneath
the Spray Unit is clean
Spray applicator control Wind in solution knob below
dial is set too low the hose connecter of the gun
To Next Page
Loading...
