Tannoy KINGDOM ROYAL - Bi-wiring Connections

42
43
43
Note the polarity marking on the cable.
At the loudspeaker end connect the
cables marked Left LF+ and LF- to the
appropriate left speaker LF terminals.
Connect the Left HF+ and HF- to the
appropriate + and - left speaker
HF terminals.
Make the same connections with the
Right LF and HF cables. Note the
polarity of the cable and be sure to
connect + to + and - to -, the LF
cables to LF terminals and HF to HF.
Switch on the amplier with the volume
turned down. Select a favourite source
and carefully turn up the volume. Check
that bass and treble sounds come from
both speakers. If not, switch off and
recheck the connections.
Bi-wiring releases the full potential
of the Tannoy Kingdom Royal
loudspeakers. Two complete sets of
cable are required. Switch the amplier
off. Deal with each ‘side’ of the system
separately. Label two of the cables Left
LF and Left HF (low frequency and high
frequency), referring to the diagram
(see g. 3).
Do the same for the right pair. Undo the
loudspeaker terminals, remove and
retain the Bi-wiring links so that the
same polarity terminals are no
longer joined.
It is essential to get the polarity correct.
If your amplier does not have separate
output terminals for bass and treble
then, at the amplier end of the cable,
connect the Left LF+ and HF+ cables
together. Then wire to the amplier Left
channel positive terminal marked +
(plus) or coloured red.
Connect the Left LF- and HF- cables
together to the amplier negative
terminal marked - (minus) or black.
BI-WIRING CONNECTIONS