Need help?Do you have a question about the Tannoy POWER V6, POWER V8, POWER V12, POWER V12HP and is the answer not in the manual?
General| Category | Speakers |
|---|---|
| Model | POWER V12HP |
| Tweeter | 1" |
| Type | Passive |
| Power Handling (RMS) | 200 W |
| Power Handling (peak) | 400 W |
| Sensitivity | 92 dB |
| Impedance | 8 Ohms |
| Woofer | 12" |
Essential safety guidelines and warnings for operating the Tannoy Power V loudspeakers.
Advice on initial setup and handling of the loudspeakers.
Illustrates common system configurations and connections for Power V speakers.
Details on power input, connectors, and voltage compatibility for the speakers.
Guidelines for ensuring adequate airflow to prevent overheating.
Explains the meaning of the Power, Signal, and Limit LEDs on the rear panel.
Describes the function of the integral limiters for speaker protection.
Information on balanced audio inputs, linking, and signal wiring standards.
Details on the yoke bracket for mounting the Tannoy V6 loudspeaker.
Information on the yoke bracket for mounting Tannoy V8 loudspeakers.
Assembly instructions for the VMY yoke bracket.
Mounting dimensions for V15Y and V12Y brackets.
Instructions for installing the VMB wall mounting bracket.
Guidelines for using VEB M10 eyebolts for flying loudspeakers.
Instructions for fitting the VTH pole mount.
Details on using the VCS ceiling saddle for suspension.
Information on the VPC pole clamp for overhead suspension.
To Next Page