20
10.7 : SECUR ET - VTH POLE MOUNT
The Tannoy Power V™ loudspeakers are fitted as standard with a
blanking plate on the base of the cabinet. However, should you ever
wish to mount the Power V™ onto a standard 35mm pole mount
this blanking plate can be quickly and easily removed and replaced
by a VTH pole mount. The same screws which secure the blanking
plate should be used to secure the VTH in position.
.
Description Quantity
VPC Pole Clamp 1
M10 Washer 1
M10 x 50mm Screw 1
M10 Nyloc Nut (Black) 1
10.8 : SECUR ET VCS CEILING SADDLE
The VCS ceiling saddle available in both black and white finishes,
and is to be used in conjunction with the VMY and a length of M10
threaded rod (not supplied by Tannoy Limited). The VCS ceiling
saddle allows the Tannoy Power V™ loudspeaker to be suspended
at a user defined distance from the ceiling as shown in Figure 1.
Included with the VCS is an M10 nut. This should be used to secure
and lock the threaded rod in place at the top of the ceiling saddle.
10.9 : SECUR ET VPC POLE CLAMP
The VPC pole clamp can be used along with the VMY yoke bracket
to suspend a Tannoy Power V™ loudspeaker from an overhead bar,
truss or suitable structure. Only the parts supplied should be used
to secure the VPC to the VMY yoke bracket.
The following items are included with each VPC:-
FIG 1.
To Next Page
Loading...
