Tannoy Precision - Technical Specifications: Precision 6.1, 6.2, 6.2 LE; Precision 6.1 Specifications; Precision 6.2 Specifications; Precision 6.2 LE Specifications

PRECISION MANUAL_09
Precision
TECHNICAL SPECIFICATIONS
Precision 6.1 Precision 6.2 Precision 6.2 LE
PERFORMANCE
Recommended amplier power
(watt RMS)
20 - 150 20 - 175
TBC
Continuous power handling
(watt RMS)
75 87
TBC
TBC
Peak power handling (watt) 300 350
TBC
Sensitivity (2.83 volt @ 1 m) 88 dB 89 dB
TBC
Nominal Impedance (ohm) 8 8
TBC
Frequency response (-6 dB) 43 Hz - 35 kHz 34 Hz - 35 kHz
TBC
Dispersion (degrees conical) 90 90
TBC
DRIVE UNITS
Dual Concentric high frequency 25 mm (1”) Titanium dome
with Tulip WaveGuide™
25 mm (1”) Titanium dome
with Tulip WaveGuide™
TBC
Dual Concentric low frequency 150 mm (6”) treated paper
pulp cone with rubber
surround. 44 mm (1.75”)
edge wound voice coil
150 mm (6”) treated paper
pulp cone with rubber
surround. 44 mm (1.75”)
edge wound voice coil
TBC
Bass Driver - 150 mm (6”) treated paper
pulp cone with rubber
surround. 44 mm (1.75”)
edge wound voice coil
TBC
Passive radiator - -
-
CROSSOVER
Crossover frequency 1.6 kHz 170 Hz, 1.6 kHz
TBC
Crossover Type Passive low loss 2nd
order LF, 1st order HF
Passive low loss 2nd
order LF, 1st order HF
TBC
CONSTRUCTION
Enclosure type Rear ported Rear ported
TBC
Volume 11.0 l (0.39 cu. ft.) 29.3 l (1.03 cu. ft.)
TBC
Dimensions (H x W x D)
(excl grille)
330 x 224 x 257 mm
(13 x 8.82 x 10.12”)
1000 x 310 x 283 mm
(39.4 x 12.2 x 11.14”)
TBC
Weight 7.3 kg (16.1 lbs) 18.4 kg (40.6 lbs)
TBC