To Next PageTo Next Page
Need help?Do you have a question about the TaoTronics TT-BA12 and is the answer not in the manual?
General| Bluetooth Version | 5.0 |
|---|---|
| Battery Life | 15 hours |
| Charging Time | 2 hours |
| Audio Codec | SBC |
| Output | 3.5mm AUX |
| Bluetooth Protocol | A2DP, AVRCP |
| Codec | SBC |
| Weight | 36 g / 1.26 oz |
| Material | Plastic |
| Certifications | CE, FCC, RoHS |
| Input | 3.5mm AUX |
| Bluetooth Range | 10 m / 33 ft |
| Ports | 3.5mm AUX |
The primary button for controlling device functions.
Dual-function LED for status and integrated microphone.
Port used for recharging the device's battery.
Standard audio jack for connecting audio devices.
Switch to select between audio transmission (TX) and reception (RX) modes.
Press and hold the Multifunction Button for 3 seconds to turn the device on or off.
Start pairing mode by double-pressing the Multifunction Button when powered on.
Slide the switch to change between Transmitter (TX) and Receiver (RX) modes.
Use the Multifunction Button to play or pause music in RX mode.
Solid red light indicates the device is currently charging.
LED being off signifies that the device has reached full charge.
Alternating red and blue flashing lights signal the device is in pairing mode.
A flashing red light indicates that the device's battery is low.
A solid blue light indicates a successful Bluetooth connection.
Flashing blue light shows the device is powered on but not yet paired.
Connect via micro-USB to any active USB port. LED is red when charging, off when full. Recommended 2-hour charge before first use.
General guide for charging and pairing. Device enters pairing mode automatically on first power-on.
Instructions for pairing the device in Transmitter mode with audio devices.
Instructions for pairing the device in Receiver mode with audio devices.
Connect two Bluetooth devices simultaneously in TX mode.
Connect two Bluetooth devices simultaneously in RX mode.
Mode switching requires the adapter to be off for 5 seconds; pairing history is cleared.
If pairing fails, turn off, switch mode, turn off again, then attempt pairing.
Adapter attempts to re-pair automatically with previously connected devices.
In TX mode, both paired devices can play music simultaneously.
In RX mode, only one device can play music at a time; requires manual switching.
Device tested and found compliant with FCC Part 15 for Class B digital devices.
Tips to correct interference: reorient antenna, increase separation, change circuit.
Device must not cause harmful interference and must accept received interference.
