07/08
Beeper & LED Denitions
Beeper
3 beeps
3 beeps
N/A
N/A
3 beeps
2 beeps
1 tick
1 short beep
1 beep
1 tick
2 beeps
LED Indicator
Blue LED On
Red LED ashes 3 times
Red LED ashes 3 times
Red LED ashes
Red LED ashes, blue LED solid on
Blue LED on
Red LED on
Blue LED on
Blue LED on
Red LED on
N/A
Indication
Power up with over 30% battery
Power up on with battery lower
than 30%
Power off with battery lower
than 20%
Battery drained
(Charge for 30 to 50 minutes,
then power on again)
Pairing
Paired (Power up then pair)
Transmission error
Code scanned and uploaded
Code scanned and saved in
inventory mode
Transmission error or insufcient
space in inventory mode
Connected to host device in
wired mode
Pair with phone, pad, or other devices.
Pair with your laptops or use the cable to connect the Bluetooth scanner.
Pair with PC without Bluetooth, you need to use a Bluetooth receiver or the wired
mode to connect with a PC without Bluetooth functionality.
3. Pair with different hosts
Turn on Bluetooth on the host device, scan the Bluetooth barcode to pair.
Charge the Barcode Scanner
Simply connect the scanner with any USB power adapter via the included USB cable.
The LED light will ash red and blue alternately while the scanner is being charged.
Battery Status
Charge the scanner if the LED indicator ashes red 3 times as low battery alarm.
Scan the barcode to learn about the battery status on your PC.
Note:
To Next Page
Loading...
Need help?
General
