TaoTronics TT-BS030 User Manual (English)

Questions and Answers:

D
dchenAug 6, 2025
Why TaoTronics TT-BS030 Barcode Reader laser is on but not decoding?
- E
  Elizabeth CarterAug 6, 2025
  If the laser on your TaoTronics Barcode Reader is active but failing to decode barcodes, consider these potential causes: 1. The scanner might not be programmed to read the barcode type. Ensure that you program the scanner to read the specific type of barcode you are attempting to scan. 2. The barcode itself may be damaged or unreadable. Inspect the barcode for any defects and try scanning known good barcodes of the same type. 3. The scanning angle or distance could be incorrect. Adjust the distance between the scanner and the barcode by moving closer or further away.
K
Katherine SolisAug 12, 2025
What to do if TaoTronics TT-BS030 Barcode Reader does not turn on?
- L
  lee68Aug 12, 2025
  If your TaoTronics Barcode Reader isn't responding or is malfunctioning (laser off, frequent beeps), there might be a power issue. Check the power connection to ensure the scanner is properly connected and receiving power, especially if your setup requires a direct power connection. Also, verify that all interface and power cables are securely connected to eliminate any loose connections.
Y
younglukeAug 21, 2025
How to fix incorrectly displayed data from TaoTronics TT-BS030?
- R
  robinsonsarahAug 21, 2025
  If the data from your TaoTronics Barcode Reader is displaying incorrectly on the host system, the scanner might not be correctly programmed to work with the host. Check the scanner's host type parameters or editing options and ensure that the proper host setting is selected.
A
acarpenterAug 28, 2025
What to do if TaoTronics Barcode Reader decodes but does not transmit?
- K
  Katie AdamsAug 28, 2025
  If your TaoTronics Barcode Reader decodes the barcode but doesn't transmit the data to the host system, the scanner may not be programmed for the correct host type. Try scanning the appropriate host type barcode to resolve this issue.