Tar River ERC Series - Torque Specifications; Torque Specifications for Common Bolt Sizes

To Next Page

To Previous Page

ERC Square Back Rotary Cutter

Notes:

This chart is an approximate estimate of torque values.

Always tighten hardware to these values unless a different torque value or tightening procedure is listed for a specific application.

Fasteners must always be replaced with the same grade as specified in the manual.

Always use the proper tool for tightening hardware: SAE for SAE hardware and Metric for Metric hardware.

Make sure that fastener threads are clean and that you properly start thread engagement.

Torque Specifications