Operation
25
Operation with tape
Timer recording using On Screen
Display (Continued)
9. Press i to set another timer record event and follow
steps 3 to 8.
Check that the timer event details are correct.
Press i return to screen.
If PLEASE CHECK is displayed, you have entered
incorrectly and will need to re-enter the data.
10. Press POWER to switch your DVD+VCR to Timer
Standby mode.
Note:
The 1W Mode is not available in the standby
mode for the timer recording.
The timer symbol ( ) will appear in the display
window while your DVD+VCR waits to make the
recording.
11. Press POWER to end timer recording.
Notes:
The DVD+VCR will automatically power off when
Timer Recording ends.
During timer recording standby mode, the DVD and
VCR mode cannot be operated. To use the
DVD+VCR, press POWER. After you use the DVD or
VCR, press POWER again to put the VCR into timer
recording standby mode.
If at a later date you wish to delete or change any of the
settings in timer event memory you may do so without
having to enter all the timer event information again.
Simply display the timer event screen. Use v or V to
select the event that you wish to delete or change.
Press b to delete the event...or
Press ENTER/OK to change; then press b or B to
select; Station, Date, Start and End times and
recording speed. Press v or V to enter the correct
information.
If Timer record events Overlap...
Make sure that the preset times of the timer recording
events do not overlap. If they do, the earlier pro-
gramme will always be given priority.
Example:
Programme 1 is programmed to start at 16:00 and
end at 17:00.
Programme 2 is programmed to start at 16:30 and
end at 17:30.
(In this case, Programme 1 will be recorded in its
entirety, but only the last 30 minutes of Programme 2
will be recorded.)
To watch a DVD while performing a timer recording,
press DVD to select DVD mode.
Programme Delivery Control (PDC)
The Programme Delivery Control (PDC) system
adjusts the start and end times of a timer record
event. This can be particularly useful with sports
events which may run over into extra time. The PDC
signal is transmitted by the broadcaster and this
controls your video recorder’s timer. Currently only a
limited number of TV companies transmit PDC
signals. Please make sure that when recording from
channels that do not broadcast PDC that you turn
PDC OFF.
To Next Page
Loading...
