Target 3-2-1 Cube - Step 3: Insert Dowels for Alignment

11
1. Quickly dip pre-glued dowel into a cup of water, making sure entire dowel gets wet.
2. Immediately push two dowels into center holes on both unnished edges of each large divider as shown.
3. Immediately push two dowels into center holes on unnished edge of each small divider as shown.
12x
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
(H1)
E
F
D
C
step 3.
(H1) x 12
pre-glued dowel