Target DT15E - Page 51

51
Notes
Revisions to this document:
Rev 0 Operating Instructions / Parts List Dated 07April1999 – First Production Unit: S/N 308084.
Rev 1 Operating Instructions / Parts List Dated 13April1999 – Minor Text Rev’s.
(Supersedes all above Instructions)
Rev 2 Operating Instructions / Parts List Dated 16November1999 – Design Change: Added Thick Washers (P/N 177947) at Accessory Disks,
Added Forward Axle Position (E2) for Diamond Disk Operation Effective S/N 323831 on 16November 1999.
(Supersedes all above Instructions)
Rev 3 Operating Instructions / Parts List Dated 04January2000 – Added Isometric Parts List to Document.
(Supersedes all above Instructions)
Rev 4 Operating Instructions / Parts List Dated 03October2000 – Added Star / Beam / Carbide Cutters (Diagram 11, 12, 13) to Parts List.
(Supersedes all above Instructions)
Rev 5 Operating Instructions / Parts List Dated 05February2001 – Added Tungsten Carbide Cutter Assy (Now Diagram 14) to Parts List. Added
New Target Decals, and Revised “Muffler Is Hot” Decal (Page 6). Added Cap P/N To Water Tank Assy (Diagram 8)
(Supersedes all above Instructions)
Rev 6 Operating Instructions / Parts List Dated 16August2002 – Revised hardware page 31, Item 22 (167631) was 167661 (120mm lg), page 37,
Item 9 & page 39, Item 21 (177884) description 65mm was 70mm. (Ref. ECO 6232) (Supersedes all above Instructions)