Do you have a question about the Tascam CC-222SL and is the answer not in the manual?
quantization bit depth | 16 bit linear |
---|---|
sampling frequency | 44.1 kHz |
frequency response | 20 Hz~20 KHz |
S/N ratio | 92 dB (playback), 88 dB (recording) |
dynamic range | 92 dB (playback), 88 dB (recording) |
total harmonic distortion | 0.006% (playback), 0.01% (recording) |
channel separation | 80 dB (playback:1kHz), 75 dB (recording:1kHz) |
wow and flutter | < 0.001 % |
digital input Fs | 32 kHz to 48 kHz (SRC ON), 44.1 kHz (SRC OFF) |
digital input coaxial | RCA pin jack (IEC60958 Consumer use) |
digital output coaxial | RCA pin jack (IEC60958 Consumer use) |
line input level | -10 dBV (Full Scale -16 dB) |
maximum input level | +6 dBV |
input impedance | 50 kØ ±10 % |
line output level | -10 dBV (Full Scale -16 dB) |
maximum output level | +6 dBV ±2 dB |
output impedance | 600 Ø ±10% |
number of channels | 4-track, 2-channel stereo |
---|---|
tape speed | 4.76 cm/s (1 7/8 ips) |
motor | DC servo motor x 1 |
wow and flutter | <0.19% (W.RMS) |
frequency response | 50 Hz — 12.5 kHz ±3 dB (high position), 50 Hz — 10 kHz ±3 dB (normal) |
signal-to-noise ratio | 46 dB (Dolby NR off), 52 dB (Dolby NR on) |
fast winding time | About 120 seconds (C-60) |
---|---|
normal input level | 0.28 V (-11 dBV) |
cartridge type | MM (moving magnet) |
input signal level | 5.6 mV |
normal output level | 0.46 V (-6.7 dBV) |
S/N ratio | 60 dB (6.3 Ø) |
output level | 10 mW + 10 mW (into 32 Ø) |
power consumption | 33 W |
---|---|
dimensions | 295 x 435 x 138 mm (11.6 x 17.13 x 5.4 in) |
weight | 7.4 kg (16.3 lb) |