1 - To turn on the unit, press and hold the HOME ■
button.
2 - Press the RECORD button once to set up the
recorder on standby.
While on standby the REC light will be blinking,
and the display will show incoming audio signal,
but the unit will not record.
3 - If you wish to, plug in your headphones on the
left side of the recorder.
4 - To ensure the recorder is set to automatic
recording levels, press the QUICK button.
5 - Select LEVEL CTRL on the display by pressing the
► button.
6 - Select AUTO LEVEL on the display by pressing the
► button.
7 - Press RECORD to start recording.
You should now see the numbers at the top of
the display running up, and the REC light should
be solid.
8 - Place the recorder as close as possible to the
person you are interviewing, but not closer than
three inches.
9 - If you wish to create marks on the recording, press the MARK button once per mark.
10 - If you wish to take a pause, press the RECORD button once. The recorder will go on standby but it
will not create a new file. To re-start the recording, press the RECORD button once.
11 - After you have concluded the interview, press the ■ button once.
12 - To transfer the audio file of the recording, plug in the recorder to a computer using the USB
connection on its right side. The recorder will appear as a flash drive containing wave audio files.
Note: The Tascam DR-05 records on WAVE format by default. Please do not change these settings. If the
settings are changed by accident, enter the MENU/REC SETTING/FORMAT and re-set it to WAV 16bit.
Need help?
General
Weight and Dimensions
