EasyManuals Logo

Task Force Tips PRO/pak Manual For Safe Operation And Maintenance

Task Force Tips PRO/pak
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
PRO/pak will not make foam
Foam is Intermittent
Poor Quality Foam
SYMPTOM
Out Of Foam
Percentage Knob is OFF
Percentage Knob is plugged
Non-standard outlet hose being used which
is too long or too small in diameter
Foam tank is nearly empty
PRO/pak tilted
Air vents are plugged
Debris in nozzle
Debris under knob
Foam solution velocity too high
Foam gets thick when cold
POSSIBLE CAUSE
Refill Tank
Select desired percentage
Remove screw on Percentage Knob,
inspect and clean holes in top of control
block and foam passages in bottom of
Percentage Knob
Order long hose option TFT part U-HS6 or
U-HS25
Refill tank
Keep Twist Grip Horizontal
Make sure that the small black rubber
valve on the inside of the foam tank lid is
not stuck down with dried foam
concentrate
Inspect nozzle, look for plugged holes
Unscrew Knob, inspect and clean
Partially close Flow Control
Select Another Foam
REMEDY
7.0 TROUBLE-SHOOTING
9.0 SPECIFICATIONS
Turn the percentage knob to the OFF position. Use the hose, or hose and
straight stream nozzle, to rinse off the PRO/pak. Reset percentage knob to
proper percentage when finished.
For years of service, periodically inspect your PRO/pak. Make sure the hose
and three nozzles are in place. Look for debris in the bottom of the tank and
flush if necessary.
If the PRO/pak is often used for different foam concentrates, it may be helpful
to install a drain to aid in emptying the tank. Drill and tap the left front ear of the
tank and install a ¼" NPT Pipe plug. Plastic or Brass preferred.
Tank Capacity (to bottom of fill port) 2.5 U.S. gallons 9.5 liters
Nominal flow (all nozzles) 12 gpm at 100 psi 45 l/min at 6.8 bar
Weight Empty 11.5 lb 5.2 kg
Weight Full 30.1 lb 13.6 kg
Length x Width x Height 13.5 x 10.75 x 17 in 345 x 275 x 430 mm
Operating Pressure Max/Min 500/40 psi 40/3 bar
Straight Stream Nozzle Reach 50 feet at 100 psi 15 meters at 6.8 bar
Low Expansion Nozzle Reach 37 feet at 100 psi 11 meters at 6.8 bar
U.S. Units Metric Units
8.0 CLEAN UP AND MAINTENANCE
8.1 DRAIN HOLE
DRILL 7/16" HOLE
TA"NPT
LEFT FRONT ONLY!

Other manuals for Task Force Tips PRO/pak

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Task Force Tips PRO/pak and is the answer not in the manual?

Task Force Tips PRO/pak Specifications

General IconGeneral
BrandTask Force Tips
ModelPRO/pak
CategoryPaint Sprayer
LanguageEnglish