OPERATING INSTRUCTIONS
ON/OFF Switch (Fig. 7)
The ON/OFF switch (1). A circuit breaker (2) is located below the switch.
To operate the shredder:
1. Plug the shredder into a properly
grounded 3-prong outlet.
2. Flip the switch (1)
to the ON
position. If the shredder does not
start, flip the switch to the OFF
position and press the reset
button
(2)
, then flip the switch to the
ON position.
3. Flip the switch (1) to the OFF
position to turn off the shredder.
Allow at least 5 seconds for the
blade to stop rotating.
Overload protection (Fig. 7)
This yard chipper has a reset overload
feature. The reset button
will restart the
motor after it shuts off due to overloading or low voltage. If the motor stops
during operation:
1.Turn the ON/OFF (1) switch to the OFF position.
2.Wait about five minutes for the motor to cool.
3.Push in on the reset button (2) .
4.Turn the switch (1) to the ON position.
12
ALWAYS ALLOW 5 SECONDS OR MORE FOR THE
BLADE
TO STOPROTATING AFTER TURNING OFF THE CHIPPER.
TO PREVENT AN ACCIDENTAL START-UP IF THE RESET
BUTTON IS PUSHED,
THE ON/OFF SWITCH SHOULD BE IN THE OFF
POSITION AND THE PLUG SHOULD BE REMOVED FROM THE POWER
SOURCE WHILE COOL DOWN TAKES PLACE.
Fig. 7
1
2
OPERATION
WARNING
WARNING
To Next Page
Loading...