Cleanup Instructions
Step 1
Insert the detergent suction tube into a container
of fresh water.
Step 2
Set the nozzle to the low-pressure setting.
Step 3
Pull and hold the gun trigger for 20~30 seconds.
Allow fresh water to rinse through the detergent
injection system.
Warning
• Never use bleach, chlorine products
and
other corrosive chemicals.
• Never use liquids containing solvents
(i.e.,
paint thinners, gasoline, oils).
• Never use ammonia products.
• Never use acid-based products.
These products can cause physical
injuries
to the operator and irreversible
damage
to the machine and/or
damage
the surface being cleaned.
Important notice
When
you have finished using detergent, always
follow
the “Cleanup Instructions”. Failure to
clean
properly will cause the injection system to
become
clogged and inoperable.
Caution
This machine has been designed for use with
pressure washer detergents only. The use of
other
detergents or chemicals may affect the
operation
of the machine and will void the
warrant
y.
Fig.10
Detergent Application
Step
1
Pull the
detergent suction tube out and
insert it into a detergent container.
Step
2
Step 3
Adjust the nozzle to low-pressure setting to
apply the detergent.
Step
4
Dep
ress the gun trigger and the detergent will
be
automatically injected and mixed with water.
Step
5
Apply
detergent to work area. Do not allow
detergent to dry on surface.
Release the gun trigger and adjust nozzle
to high pressure setting. Depress the gun
trigger and rinse the surface in a sweeping
motion.
Note: To apply detergent, the adjustable
nozzle must
be in the low-pressure position.
To enhance the efficiency of the pressure washer,
sometimes it is necessary to use detergents to
help loosen tough dirt and grime.
Using the detergent
WORKING WITH DETERGENTS
8
To Next Page
Loading...
