Fig. 3
Fig. 2
Fig. 1
Make sure that the ON/OFF switch is in the
“OFF” position.
Separate the adaptor and quick-connect
coupling. Attach inlet adaptor to the machine’s
inlet and attach the quick-connect coupling
onto the garden hose.
Insert the wand into spray gun, and twist 1/4 turn until rectangular tab appears.
Step
1 Step 2
Step 3
Do not draw non-water liquids through the unit. For
use
with cold water supply only.
Water hose
must be at least a 1/2” in diameter.
Flow
rate of water supply must not fall below 2 GPM
(gallons
per minute).
Flow
rate can be determined by running the water
for
one minute into an empty 5-gallon container.
The
water supply temperature must not exceed
104°F (40°C
).
Water Supply (Cold Water Only)
•
•
•
•
•
Caution
To prolong the life of the unit, it is
recommended to rest the unit 5 minutes
after every 30 minutes of use.
Caution
•
•
•
Never
use the pressure washer to draw in
water
contaminated with solvents (e.g.
paint
thinners, gasoline, oil, etc.).
Dirt
in the feed water will damage the unit.
To avoid this risk, we recommend
checking
the water filter (located inside
the
water inlet; to clean it out see
Maintenance
section on page 11).
Always
prevent debris from being drawn
into
the unit by using a clean water
sou
rce and an accessory water filter if
required.
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects which could create a
hazard. Remove from the workarea which could be tripped over, such as toys or outdoor furniture.
Ensure that all doors and windows are closed tight.
Assembly Time: 2 minutes / Tools Required: None
ASSEMBLY AND OPERATING INSTRUCTIONS
4
To Next Page
Loading...
