41
Emptying the cleaning solution
Cleaning the pad
Cleaning the machine
Storing / parking the machine (not in operation)
Service, maintenance and care
The maintenance of the machine is a prerequisite for impec-
cable operation and a long service life.
Service intervals
TASKI machines are high-quality machines that have been
checked for safety in the factory and by authorized inspectors.
Electrical and mechanical parts are subject to wear and aging
after a longer period of use.
Service center
Please always indicate the type and number of the machine
whenever you contact us for order placing or in case of mal-
functions.
The required data are provided on the nameplate of your ma-
chine. The address of your closest TASKI service partner is
provided on the last page of this instruction of use.
• Clean the power supply cord with a
damp cloth and roll the cord loosely
around the handle bar and cable
hook.
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
• Remove the water tank from the machine and empty it.
• Empty the product tank of the dispensing unit.
Notice:
For the procedure for emptying the foam
generator see the Instructions for use for
the foam generator 2.
• Put the pad in a cleaning solution for a few hours and rinse
it thoroughly afterwards.
Notice:
The pad can also be cleaned in the wash-
ing machine at max. 40°C.
• Leave the pad to dry.
Attention:
Do not tumble-dry the pad!
Attention:
Never clean the machine with a high-pres-
sure cleaner or water jet.
Water ingress in the machine may cause
considerable damage to the mechanical or
electrical parts.
• Wipe the machine with a moist cloth.
Notice:
The machine must be switched off and the
plug must be removed from the mains
socket.
Notice:
Store the machine with the tool lifted.
Attention:
Always remove the mains plug from the
mains socket when carrying out mainte-
nance work!
Attention:
Use original TASKI parts only; otherwise,
any warranty and liability claims will ex-
pire.
Legend:
◊ = whenever cleaning is completed, ◊◊ = every week,
◊◊◊ = every month, ⊗ = service lamp
Activity
◊
◊◊
◊◊◊
⊗
Page
Check the motor ventilation for dust ac-
cumulation, clean if necessary
●
Empty the spray unit and rinse with
warm water
●
Clean the tool (brushes) ● 41
Clean and dry the pad ● 41
Clean the machine with a moist cloth ●
• In order to maintain operational safety and readiness for
use, the machine must be serviced after 250 working hours
or at least once a year.
Notice:
In case of extraordinary use and/or insuffi-
cient maintenance, shorter intervals are
required.
EN
To Next Page
Loading...
