44
Malfunctions Transport
Transport the machine in an upright position and remove the batteries for
transportation where necessary.
Ensure that the machine is firmly lashed down and secured in the transport
vehicle.
Disposal
When it has reached the end of its operational life, the machine and its
accessories must be disposed of according to the national regulations. Your
TASKI partner can support you with proper disposal upon notification.
Batteries
The batteries must be removed from the machine before being disposed of
properly.
Used batteries must be disposed of in an environmentally appropriate way in
accordance with the EU guidelines 2006/66/EEC.
Technical data
Malfunction Possible causes Troubleshooting page
Machine does not
run
Maschine switched off
• Switch on the
keyswitch.
37
• Connect the battery to
the machine with the
battery disconnection
socket.
37
Battery/mains
unit malfunction
(display on con-
trol panel)
Discharged batteries
• Recharge batteries
38
Batteries/battery
charger defective
• Call for technical
assistence
Batteries not suf-
ficiently charged
Power cord not
plugged in or defecti-
ve
• Plug in the power cord
• Call for technical
assistence
Batteries or battery
charging unit defecti-
ve
• Call for technical
assistence
Brush does not
turn
Motor runs but not
tool
• Call for technical
assistence
Poor vacuum
performance
Floor remains
wet
Soiled solution
not picked up
The float closes the
inlet opening at the
suction unit (overfill
protection for recove-
ry tank)
• Check the recovery
tank is not full
41
• Check that the float is
functioning correctly.
43
Squeegee not on the
floor
• Lower the squeegee.
41
Suction hose not con-
nected
• Connect suction hose
Check the seal on the
tank lid for cracks/dirt
• Clean the seal, or
replace if defective
Vacuum air filter blo-
cked
• Remove the blockage
Hose or nozzle blo-
cked (e.g. by pieces
of wood or residual
material)
• Remove the blockage
The blades do not ad-
just well to the floor
consistancy
• Clean the squeegee
• Change/turn the
blades
43
• Check that the
squeegee suspension
is functioning correctly
Dirt sieve full (yellow)
• Remove the dirt sieve
• Knock out the coarse
dirt from the sieve and
rinse it under running
water.
41
Vacuum switched
off
Recovery tank full
• Empty the recovery
tank
41
Insufficient out-
flow of cleaning
solution
Solution tank empty
• Fill the solution tank
40
Solution tank filter blo-
cked
• Clean solution tank
filter
42
Foam or liquid
leaking from the
machine
Float malfunction
• Turn off the suction
aggregate
37
• Check that the float is
functioning correctly.
43
Machine swingo
755
swingo
855
swingo
1255
type CO755.1/
CO755.1X
CO855.1/
CO855.1X
CO1255.1/
CO1255.1X
Theoretical performance
area operation width x
drive speed (4,5) x 1000
1935 2250 2475 m2/h
Working speed 4.5 4.5 4.5 km/h
Working width 43 50 55 cm
Squeegee width 69 69 80 cm
Solution tank nominal 40 40 60 l
Recovery tank 40 40 60 l
Machine weight for
operation
160 160 260 kg
Rated voltage 24V 24V 24V DC
Tools 1 x 43 1 x 50 2 x 28 cm
Brush rpm 165 165 195 min-1
Brush pressure 43 43 48 kg
Dimensions (L x W x H) 116x47.5x
119.5
122x53x
119.5
142x58x117 cm
Rated power 900 900 1000 W
A-weighted emission
sound pressure level
ISO 11201
<70 <70 <70 dB(A)
Vibrationtotal value of the
Hand-Arm system
ISO 5349
<0.5 <0.5 <0.5 m /s2
Splash water protection IPX3 IPX3 IPX3
Protection class without
battery charger (only
model: CO1255.1/
CO1255.2)
III
Protection class (without
battery charger). Only
model: CO755.1/
CO855.1
III III
Protection class with
battery charger
I (II) I (II) I (II)
To Next Page
Loading...
Need help?
General
