42
Clean solution tank filter
Cleaning the tools
Variant: (Option 1255) Automatic brush lowering
Pedal brush unit (optional):
Swingo 1255B model:
Swingo 755B/855B model:
Removing and cleaning the squeegee
Cleaning the machine
Storage / parking of machine (machine is idle)
Store the machine with the tank cap slightly open, by:
• lifting the tank lid and turning the dosing aid upside down.
• then rest the tank lid on the dosing aid.
Service, maintenance and care
The machine's maintenance is a pre-condition for trouble-free running and a
long life.
Caution:
Clogged filters reduce the flow of the cleaning solution. As a
consequence you may damage the floor coating.
• Switch the machine off.
• Once the solution tank has been drained, screw
the yellow cap from the solution tank filter and
pull it away from its holder.
• Rinse the filter under running water.
If necessary, the filter should be descaled with a 10% TASKI calcacid
solution.
The filter is lower than the tank outflow. A residual amount of
solution will flow out once the filter cap has been unscrewed.
• Refit the solution filter.
• Switch on the keyswitch.
The indicators light up briefly.
• Press the brush unit button to raise the tool.
• Switch the machine off using the keyswitch and remove the key.
• Switch the machine off using the keyswitch and remove the key.
• To raise the tool, press down the pedal and lock
it in place.
• Press the tool ejection handle briefly but firmly
with your foot.
• Clean the tool under running water.
• Turn the tool anticlockwise away from the tool
coupling using your foot.
• Clean the tool under running water.
• Switch the machine off.
• Pull the suction hose away from the squeegee support.
• LIft the squeegee with the foot.
• Press the locking springs together. The
squeegee will thereby be released and can be
removed.
• Clean the squeegee with water using a brush.
Optimal suction results can only be obtained with clean and intact
blades!
Caution:
Never clean the machine with high water pressure or a water
hose.
The ingress of water into the machine might cause considerable
damage to mechanical or electrical parts.
• Wipe down the machine with a damp cloth.
We recommend that you disconnect the battery from the machine
using the battery disconnection socket when storing / parking the
machine and when charging the battery.
The dosing aid holds the tank lid slightly open,
allowing the tank to dry out. As a result, the
formation of mould and unpleasant smells can
be reduced.
Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
Symbols:
= After use, = Every week, = Every month, ⊗ = Service light
Activity ⊗ page
Recharge batteries
38
Clean all parts marked yellow
Drain and clean the tanks 41
Wipe down the machine with a damp cloth
42
Refill distilled water (wet batteries). Please follow
the manufacturers instructions of use booklet for
these batteries!
Clean the tank lid seal, check for cracks and repla-
ce if necessary
Maintenance programs by TASKI service made by
TASKI technician
To Next Page
Loading...
Need help?
General
