106
Error codes
Error codes are indicated on the display.
Transport
Disposal
Batteries
Notice:
Switch the machine off and on again
whenever an error code occurs.
Error codes might be remedied by switch-
ing the machine off and on.
Code Description Remedy
E 020 Battery in deep discharge
The battery voltage fell below 20.5V.
Machine requires complete charging
cycle.
Contact your service partner
E 041 The current difference between the brush motors is higher than 50% for 15
sec.
The brush unit is lifted.
Switch off the machine and let it cool
down.
Contact your service partner
E 048 Short circuit detection or overload condition (e.g. blocked wheels or brush-
es)
Traction motor, brush motor or suction motor is switched off.
Contact your service partner
E 051 Incorrect parameters
The parameter checksum is incorrect.
Contact your service partner
Attention:
This machine may only be lifted using lift-
ing gear (e.g. hoist, loading ramp, etc.).
Notice:
Transport the machine in an upright posi-
tion.
Notice:
Make sure that the machine is lashed and
secured in the transport vehicle.
Notice:
After withdrawal from service, the machine
and accessory parts must be adequately
disposed of in compliance with the nation-
al regulations. Please contact your Di-
versey service partner for help.
Attention:
Remove all batteries from the machine pri-
or to disposal.
Used batteries must be disposed of in an
environmentally friendly way in compli-
ance with the EC directive 2006/66/EC or
the respective national regulations.
To Next Page
Loading...
