Taski vacumat 12 - Prior to Commissioning

69
Prior to commissioning
Wet vacuuming with vacumat 12/22/22T
Check that the float housing is properly mounted and the ma-
chine is ready for the correct cleaning method, if not:
• Remove the insert for dry vacuuming and the double-filter
paper sack.
• Remove any residual dirt from the tank.
Additional instructions for wet vacuuming with vacumat 22T
Dry vacuuming
• Remove the wet vacuuming insert.
• Remove any residual dirt from the tank.
• Clean the tank with water and leave it to dry.
Application technique
• Pull the snap handle [1] upwards and
lift off the vacuum lid.
• Insert the float housing back into place.
The arrow has to point towards the intake.
• Insert the cam of the vacuum lid into
the corresponding guide and press
the snap handle down until it locks
with an audible click.
• Assemble the wet suction set.
• Attach the suction hose (squeegee) to the intake.
• Fit the bumper into the end of the
pipe on the tilting chassis and tighten
the star screws.
• Push the Fixomat squeegee holder
into the specified opening and latch it
into place.
The Fixomat squeegee is in the park -
ing position.
• Loosen the fixation screws on the
squeegee, mount the squeegee and
tighten the screws again.
The fixation screws must be posi -
tioned above the squeegee holder.
• Attach the suction hose (squeegee) to the intake.
• Lift and push the Fixomat squeegee
holder towards the tank as far as it
will go and lower the Fixomat squee-
gee. Use the screw [3] to adjust the
squeegee to the floor.
The Fixomat squeegee is in the
working position.
Attention:
This machine must never be operated
without the double-filter paper bag!
Attention:
This machine must never be operated
without the filter cloth.
1
2
1
2
1
2
1
2
1
2
3
Notice:
The Fixomat squeegee is unsuitable for
dry suction use.
Notice:
You can find the accessories for dry vacu-
uming on page 74 of these Instructions of
use.
• Pull the snap handle [1] upwards and
lift off the vacuum lid.
• Pull the double-filter paper bag over
the intake.
The rubber flange of the double-filter
paper bag must be behind the cam of
the intake!
• Insert the filter basket.
The arrow has to point towards the
intake.
• Insert the cam of the vacuum lid into
the corresponding guide and press
the snap handle down until it locks
with an audible click.
• Assemble the dry vacuuming set.
• Attach the suction hose to the intake.
Machine vacumat 12/22/22T
Wet cleaning Yes
Dry cleaning Yes
Cleaning parquet and laminate
floors
No
1
2
1
2
EN