tau K590M User Manual

19
REMOTE PROGRAMMING BY MEANS OF T-4RP and K-SLIM-RP (V 4.X)
With the new version of software V 4.X it is possible to carry out a remote self-learning of transmitters
T-4RP and K-SLIM-RP (new version V 4.X), without pressing the receiver’s programming buttons.
It will be sucient to have an already programmed transmitter on the receiver in order to start the
procedure of remote programming of the new transmitters. Follow the procedure written on the in-
structions of the transmitters T-4RP and K-SLIM-RP (V 4.X).
CANCELLING CODES FROM RADIO CONTROL DEVICES
1_ keep button CH1 pressed for 3 seconds in order to cancel all the associated transmitters;
2_ The green LED DL1V ashes slowly to indicate that the cancellation mode has been activated;
3_ press button CH1 again for 3 seconds;
4_ The green LED DL1V turns o for approx. 3 seconds and then remains steady to indicate that the
codes has been cancelled;
5_ repeat the procedure from point 1 using button CH2 to cancel all the associated transmitters;
6_ repeat procedure from point 1 using CH1 and CH2 buttons at the same time to erase all transmit-
ters programmed into the third channel;
7_ to exit the cancelling mode without deleting any code, press button CH1 or CH2 briey.
MEMORY CAPACITY
The code memory capacity* can be expanded from 30 to 126, 254 or 1022 codes (transmitters) by replacing
the memory cards as follows (plug them onto M5 connector, see wiring diagram) :
126 codes Art. 250SM126
254 codes Art. 250SM254
1022 codes Art. 250SM1022
* Control units are supplied with a standard built-in 30-code memory. The memory card for enhancing the
code memory capacity must be ordered separately.
To allow the previously stored codes (max. 30) to be moved to the control unit, it is required to install
a memory card, making sure that the control unit is at that time o and that the memory card is brand
new and therefore completely empty.
When the control unit is restarted, the codes will automatically move to the memory card.
Moving the codes from the control unit to the memory card does not work if on the memory
card used, radio control codes have already been stored and the memory card has been subse-
quently erased.
To insert new radio controls, the operation described above shall be repeated.
WARNING: Control unit must be turned OFF to insert / remove a memory card.
RADIO MEMORY RESET:
- press without releasing the keys CH1 and PROG until the DL1R (red) led stays on and the DL1V
(green) led starts ashing quickly. At this point release the keys and press them again till the LEDs
go o conrming the operation is complete.
HARD RESET (factory setting):
- press without releasing keys CH2 and PROG till LED DL1R start ashing quickly with a red light. At
this point release the keys and press them again till the LED go o (reset in progress), conrming
the operation is complete. When the unit starts again saving will be required.
In case of Hard Reset the memory of the radio receiver will not be erased: all existing
transmitters remain programmed.
8. ADVANCED FUNCTIONS
Clock function: a timer can be connected to the open-close pushbutton in order to keep the gate open
at certain times during the day, after which it reverts to automatic closing.
Note: the gate remains open as long as the Op/Cl input continues to be activated.
ENGLISH

tau K590M Specifications

General

Brand	tau
Model	K590M
Category	Control Unit
Language	English