Taurus AP2030 - Operating Instructions and Maintenance; Before Use and Initial Operation; Appliance Operation and Controls; Filter Status and Night Light

ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off button.
- Unplug the appliance from the mains.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Do not wash the lter.
- Do not use a vacuum cleaner to clean the lter.
- Sterilize the lter under sunlight regulary.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance’s
useful life and could become unsafe to use.
SUPPLIES
- Supplies can be acquired from distributors and
authorised establishments (such as lters, etc.)
for your appliance model.
SPECIFICATIONS:
- Protection degree: IPX0
- Applied part type: BF
- Weight: 2,07 Kg
- Acoustic pressure level < 60 dB(A)
- Vibration < N/A m/s2
- Operating temperature: 0°C~35°C
- Storage temperature: -15°C~35°C~
NB: These specications are subject to change
without notice of purpose of improvement.
- The plug must be easily accessible so it can be
disconnected in an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product’s packaging has
been removed.
- Remove the appliance’s protective lm and
follow gure 1.
- To eliminate the smell given off by the appli-
ance when used for the rst time, it is recom-
mended to have it on at full power for 2 hours in
a well-ventilated room.
- Prepare the appliance according to the function
you wish to use.
USE:
- Extend the cable completely before plugging
it in.
- Attach the appliance to its base / connector
making sure that it is correctly tted into place.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off
button.
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated
by using the speed regulator control (C). This
function is very useful, as it makes it possible
to adapt the speed of the appliance to the type
of work that needs to be done.
TIMER FUNCTION:
- The appliance’s operating time can be con-
trolled.
- To program the operating time simply select it
using the (B) button.
- The time programmed or remaining time will
appear on the display.
FILTER BUTTON:
- When the lter life expires (about 2200hr), the
lter replacement indicator (light bar will light
in red) to remind you, it is high time to change
the lter.
- Please replace the lter consulting gure 1.
- After changing the lter, hold the “ON/OFF”
button for 7 seconds to reset.
NIGHT LIGHT BUTTON:
- Light bar has 3 positions: Soft, standard, off.