Taurus Mycook - Page 28

ENGLISH
2928
When mounting the gasket, ensure that the thick side
is in contact with the lid.
CAUTION.
Never use the lid without rst ensuring that the
gasket is properly tted. (Figures 6 and 7).
CAUTION.
Never open the jug lid when the appliance is
running to prevent the risk of overowing and
/ or burns. Before opening the jug lid, stop the
Mycook and wait a few seconds until the blades
have come to a complete stop.
The jug
(Figure 8)
The jug has a maximum capacity of 2 litres. Contains
1 litre, 1.5 litre and 2 litre measurement levels in the
interior.
To remove lid from the jug:
Slide the handle tab downwards, pulling it to remove
it once the lid becomes detached. (Figure 9).
To t the lid on the jug:
Insert the back ap into the handle slot (Figure 10),
lower the front part and push the lid in the direction
indicated by the arrow until you hear a click (Figure
11), indicating that it has properly locked.
To attach the jug:
Take the jug and turn it anti-clockwise until the arrow
on the jug base lines up with the central unit lock.
(Figure 12).
To detach the jug:
Take the jug by the handle and turn it clockwise until it
stops (with the two arrows lined up) and lift it upwards
(Figure 13).
Jug lid
(1)
Figure 7
(1) This thick side of the board should be
mounted in contact with the lid.
Figure 8
Figure 9
Figure 10
Figure 11
Manual Mycooks.indb 28 12/11/15 16:27