BEFORE YOU BEGIN:
,
.
\
1. IMPORTANT: Insert batteries Into lhe home receiver unit first, then the
remote sensor.
2. Place the home unit as close s possible to the remote unit. This will
help with synchronization between the remote sensor and the home unit.
3. REMEMBER: Once you are ready to position your remote sensor and
home unit, ensure that the distance is not outside the effective trans-
mission range (100 feet). Some building materl Is and location of the
home unit or remote sensor can affect transmls Ion quality and range.
Try various locations for best results.
BATTERY INSTALLATION
Home Receiver:
Lift off the battery cover on the b ck of the unit. Inst II 2\alkaline AA bat-
teries according to the polarity Indicated. Close the battery cover.
Remote Sensor:
Loosen the 4 screws securing the battery cover with a small screwdriver and
remove. Insert 2 alkaline AM batteries according to the polarity direction
indicated. Replace the cover and tighten the 4 screws.
\'
\
NOTE: There are no consumer serviceable parts. All questions or
service request should directed to our consumer relations department.
(See warr,nt
y
section for contact information.)
\
A maximum of 3 remote sensor units can be registered. One
remote s~nsor is included. To purchase additional Remote
Sensors (Taylor model 1437), please call 1-877-858-0065 Monday-
Friday sam to 6pm CST'or visit www.partshelf.com
\
\
\
SETTING UP THE WIRELESS
THERMOMETER:
If you encounter any difficulties in setting up your wireless thermometer
system, please contact Consumer Relations.
• For the first installation, always insert batteries into the home unit FIRST
and then the remote sensor(s). (See BATTERY INSTALLATION section)
• Your new RF Thermometer is built with random security code technology,
the home unit will learn the random code of the first remote sensor and
log it in as channell. Channel 2 and Channel 3 will be registered in the
same way if additional sensors are used. This unit can monitor up to 3
separate sensors. (Taylor model 1437, sold separately).
• Once a channel is registered, it will not accept any new sensors. However,
registered channels can be erased by removing the batteries in the
remote sensor or the home unit.
• When replacing batteries for the remote sensor- Remember to clear the
corresponding channel of the home unit by removing the batteries. -OR-
Select the respective channel of the sensor by pressing the CHANNEL
button. Hold the CHANNEL button for 3 seconds to clear the registration.
• When replacing batteries for the home receiver- Please remove the bat-
teries of all remote sensors. Once you have replaced the home receiver
batteries, re-install the batteries to the sensors according to the desired
channel sequence. This will ensure that the unit and the remote sensors
are properly synchronized.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• It is recommended to test the units next to each other to ensure that both
the remote sensor and home receiver are properly synchronized.
NOTE: Keep the remote sensor out of direct sunlight and rain. Do not
mount on metal surface.
SETTING TIME
About the Atomic Clock
The National Institute of Standard and Technology (NIST) in Fort Collins,
Colorado broadcasts the time signal (WWVB at 60kHz AM radio signal) with
an accuracy of 1 second per every 3,000 years. The signal will able to cover
over a distance up to 2,000 miles from the source. Like a typical AM radio,
your Atomic Clock will not able to receive the WWVB signal in places sur-
3
To Next Page
Loading...
Need help?
General
