Taylor 1730 - User Manual

Wireless Indoor/Outdoor Thermometer & Clock with Remote Sensor
Model 1730
Simple, reliable, accurate…the wireless thermometer & clock allows you to monitor indoor or
outdoor locations from one room. The base station reads indoor conditions, while the remote
sensor wirelessly reports outdoor weather conditions back to the base station for an all-in-one
weather display.
NOTE: Some stations have a static cling label over the digital display. Please remove it before use.
BATTERY INFORMATION
IMPORTANT: Install batteries in the base station first, then the remote sensor, otherwise the
stations’ transmissions may not properly connect. Place the base station as close as possible to
the remote sensor when installing batteries.
Base Station:
The base station operates on 2 AAA batteries (not included). The battery compartment is located
on the back of the station. Remove the battery compartment door. Install (2) AAA size batteries
into the battery compartment according to the polarity markings. Replace the battery
compartment door.
Remote Sensor:
The remote sensor operates on 2 AAA batteries (not included). The battery compartment is
located on the back of the station. Slide off the battery compartment cover. Install (2) AAA size
batteries into the battery compartment according to the polarity markings. Replace the battery
compartment door.
After Batteries are Installed:
When the stations are powered up, the LCD screen on the base station will light up for 3 seconds,
then the station will display initial indoor temperature readings. The outdoor temperature
display will show dashes “(--)”.
Press and hold the button on the front of the base station to activate the paring to obtain
outdoor temperature. A transmission signal icon (“
”) flashes by the “OUT” temperature digits
during this time. When the “
” icon turns off, the base station has connected with the remote
and starts reporting the current outdoor temperature.

Summary

Battery Information

Base Station Battery Installation

Instructions for installing AAA batteries into the base station unit.

Remote Sensor Battery Installation

Instructions for installing AAA batteries into the remote sensor unit.

Post Battery Installation Steps

Details initial power-up, display, and pairing process for connection.

Low Battery Indicators

Displaying the Weather Station

Base Station Placement Guide

Guidance on positioning the base station for optimal viewing.

Remote Sensor Placement Guide

Instructions for optimal placement of the remote sensor.

Temperature Readings

Unit and Display Selection

How to switch between Fahrenheit/Celsius and indoor/outdoor displays.

Clock Setting Procedure

Maximum;Minimum Temperature Recall

Recalling and Clearing Records

How to view, clear, and reset max/min temperature memories.

Problem Solving Guide

Transmission Collision Issues

Important Precautions

General Safety and Handling

Covers usage, cleaning, battery, and environmental precautions.

Product Specifications

Taylor 1730 Specifications

General

Probe Type	Stainless Steel
Display	LCD
Waterproof	No
Type	Digital Thermometer
Resolution	0.1°F (0.1°C)
Auto-off	Yes