Taylor 2752 - Mounting the Wind Gauge Sensor; Mounting into the Ground

11
To mount the Wind Gauge Sensor into the ground:
1. Select a location on an open, flat area of ground with the fewest
obstructions possible for best wind accuracy. Choose a spot with soft soil,
so as not to damage the mast when going into the ground, but firm
enough that the mast will not tip over after going in the ground. No
cables, pipes or other objects should be under the ground at this location.
2. Push one end of the mast slightly into the ground. Place a wood block
against the other end of the mast. Tap the block with a hammer or mallet
against the block until the mast is buried deep enough in the ground to
be stable.
3. Attach the remote Wind Gauge Sensor to the mast as previously
described.
Mounting the Wind Gauge Sensor(continued)
Ground mount
Roof mount
Antenna
mount
Any location selected should
have the fewest obstructions
possible for best wind accuracy.